Redemac Autolabel D43, Руководство пользователя

Страница: 21 / 38

To clean the Print Roll, open the Printhead Handle. The Print Roll is now accessible for cleaning. It is
best cleaned with soap and water, but isopropyl alcohol (also known as isopropanol) can also be used.
The Print Roll can also easily be removed from the machine for offline cleaning, see section 4.4 for
details.
4.3 Changing the Print Head
The Print Head is a replaceable part that has a life of up to 150 km in a clean environment. To
maximize the life time, perform regular cleaning of the print head as described in point 4.1 above.
When the Print Head is worn out it will have one or more thin white stripes along the print direction
where the black print marks are missing on the label.
Follow these steps to change the Print Head:
1. Remove the Print Head Cover by grabbing the ribbed part and pulling it away from the
machine.
2. Disconnect the two cables that are attached to the Print Head. The machine can be left
powered on during this operation.
3. Move the Printhead Handle to the open position.
4. Disengage the Print Head by pulling it from the machine. No tools are needed since it is only
attached with a magnet.
5. Install a new Print Head. It should snap into place when it is in the correct position.
6. Place the Printhead Handle in the closed position. The machine will calibrate the media sensor
and feed the label paper to the starting position.
7. Connect the two cables to the Print Head.
8. Snap the Print Head Cover into place.
4.4 Changing the Print Roll and Belt
The Print Roll is a replaceable part. It has a life of up to 600 km or 2 years in a clean environment. The
Belt should be replaced at the same time as the Print Roll. To maximize the life time, perform regular
cleaning of the print roll as described in point 4.2 above.
Refer to this diagram during the operation:
21
www.redemac.com 888-335-9570