9. Use a 3 mm hex key to tighten the four (4) M4x0.7 x 12 mm captive screws by about two (2) turns. DO NOT FULLY
TIGHTEN.
Figure: Install M4x0.7 x 12.5 mm Captive Screws
10. Fully tighten the 1/4-20 x 12 mm screws. DO NOT OVERTIGHTEN.
11. Tighten the M4x0.7 x 12.5 mm captive screws in a cross pattern. DO NOT OVERTIGHTEN.
12. Reattach any accessories that you removed from the BRAIN.
13. Upgrade your firmware or perform a hardware rediscover to ensure that your camera recognizes the new fan. For
more information, go to
"Configure Firmware" on page 27
NOTE:
The top fan may not run immediately after turning on the BRAIN, as the top fan runs only when the BRAIN
requires additional cooling power.
NOTE:
If you need to replace any screws, submit a Support ticket at
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 2 , R EV - N
|
2 6
DSMC FAN 2.0 UPGRADE INSTRUCTIONS
