14
PILOT
Control Knob
PUSH
IN
1. Read and understand all operating instructions before lighting.
2. Burner control knob mus
0ƫ!ƫ%*ƫ0$!ƫė
F” position.
3. Connect propane (LP) cylinder (see above pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use your other hand to
ƫƫƫƫ,1/$ƫ* ƫ01.*ƫ0$!ƫ+*0.+(ƫ'*+ƫ0+ƫ0$!ƫė%(+0Ęƫ,+/%0%+*ƫ0+ƫ(%#$0ƫ0$!ƫ,%(+0ƫ
ƫƫƫƫý)!ċƫ "ƫ%#*%0%+*ƫ +!/ƫƫ%))! %0!(5ƫ0'!ƫ,(!ƫ+*ƫ,%(+0Čƫ01.*ƫ0$!ƫ
ƫƫƫƫ1.*!.ƫ+*0.+(ƫ'*+ƫ0+ƫŎŎČƫ3%0ƫĆƫ)%*10!/ƫ"+.ƫ#/ƫ0+ƫ(!.ƫ* ƫ.!,!0
the lighting procedure. If pilot still will not light, refer to the Troubleshooting Section.
7.
"0!.ƫ%#*%0%+*Čƫ.!(!/!ƫ0$!ƫ%#*%0!.ƫ100+*ƫ* ƫ'!!,ƫ1.*!.ƫ+*0.+(ƫ*+ƫ,.!//! ƫ%*ƫ"+.ƫāĆġăĀƫ
seconds after ignition.
ĉċƫ!(!/!ƫ1.*!.ƫ+*0.+(ƫ'*+ċƫ%(+0ƫý)!ƫ3%((ƫ.!)%*ƫ(%0ċƫ "ƫ*+0Čƫ.!01.*ƫ0+ƫ0!,ƫāċ
Using the Igniter
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
9.
*!ƫ0$!ƫ,%(+0ƫ%/ƫ(%0Čƫ01.*ƫ0$!ƫ1.*!.ƫ+*0.+(ƫ'*+ƫ0+ƫŎ+3Ŏƫ,+/%0%+*ċƫ%*ƫ1.*!.ƫ3%((ƫ(%#$0ƫ
ƫƫƫƫ%))! %0!(5ċƫ "ƫ*+0Čƫ01.*ƫ+*0.+(ƫ'*+ƫ0+ƫ0$!ƫėûĘƫ,+/%0%+*ƫ* ƫ01.*ƫ#/ƫ+ûƫ0ƫ0$!ƫ/+1.!Čƫ
wait 5 minutes until gas has cleared and repeat
lighting procedure. If main burner still will not light,
refer to the Troubleshooting Section.
WARNING
"ƫ1.*!.ƫý)!ƫ#+!/ƫ+10ƫ 1.%*#ƫ+,!
ration,
immediat
!(5ƫ01.*ƫ0$!ƫ+*0.+(ƫ'*+ƫė
F” and let the gas
(!.ƫƫ)%*%)1)ƫ+"ƫĆƫ)%*10!/ƫ!"+.!ƫ00!),0%*#ƫ0+ƫ.!ġ(%#$0
the fireplace.
!
!
WARNING
!
Lighting Instructions
ƫ
ƫ
ƫƫƫƫƫƫƫƫƫ+ƫ*+0ƫ3!.ƫ(++/!ƫ+.ƫý))(!ƫ(+0$%*#
while lighting fire table.
Using a Long Match or Lighter
2.
1. Prior to lighting, use a shovel to move the lava rocks for access to the pilot.
5.
*!ƫ0$!ƫ,%(+0ƫ%/ƫ(%0Čƫ01.*ƫ0$!ƫ1.*!.ƫ+*0.+(ƫ'*+ƫ0+ƫ
ƫƫƫƫŎ+3Ŏƫ,+/%0%+*ċƫ%*ƫ1.*!.ƫ3%((ƫ(%#$0ƫ%))! %0!(5ċƫ
ƫƫƫƫƫ "ƫ*+0Čƫ01.*ƫ+*0.+(ƫ'*+ƫ0+ƫ0$!ƫėûĘƫ,+/%0%+*ƫ* ƫ01.*
ƫƫƫƫƫ#/ƫ+ûƫ0ƫ0$!ƫ/+1.!Čƫ3%0ƫĆƫ)%*10!/ƫ1*0%(ƫ#/ƫ$/
cleared and repeat lighting procedure. If main burner
still will not light, refer to the Troubleshooting Section.
Wearing heat resistant gloves, position the burning long match or burning butane
(%#$0!.ƫ*!.ƫ0$!ƫ,%(+0ċƫƫƫ
lean over the fire table while lighting!
3.
1.*ƫ+*0.+(ƫ'*+ƫ+1*0!.(+'3%/!ƫ0+ƫė%(+0Ęƫ0+ƫ(%#$0ƫ0$!ƫ,%(+0ƫý)!ċƫ "ƫ%#*%0%+*ƫ
ƫƫƫƫ +!/ƫƫ%))! %0!(5ƫ0'!ƫ,(!ƫ+*ƫ,%(+0Čƫ01.*ƫ0$!ƫ1.*!.ƫ+*0.+(ƫ'*+ƫ0+ƫŎŎČƫ
wait 5 minutes for gas to clear and repeat the lighting procedure. If pilot still will not
light, refer to the Troubleshooting Section.
4. Remove long match/long butane lighter.
7. Adjus
0ƫ0$!ƫý)!ƫ
to the desired height with the control knob.
8
Note: For initial start or after any cylinder change, continue to push the Control Knob IN
for 2 minutes to purge air from gas lines before proceeding.
āĀċƫ &1/0ƫ0$!ƫý)!ƫ0+ƫ0$!ƫ !/%.! ƫ$!%#$0ƫ3%0$ƫ0$!ƫ
control knob
6. After lighting, use a shovel and heat resistant gloves to carefully move the lava rocks back
into their proper position.
