Real Flame ELEMENT 1200, Инструкция по установке и эксплуатации

Страница: 31 / 47

31
Page
D O O R R E M O VA L A N D F I T M E N T
Door removal (recommended 2 persons)
Lift and remove lower trim cover plate (1200 models)
(magnetic)
Lift up lower trim (1800 models) (Lift vertically to remove
from location pins)
Using 2 people lift door carefully, supporting both the
glass and frame. Hold vertically and gently lower down
into angle support brackets.
On 1200 models remove the 4 screws holding the lower
trim and lift away from door.
Remove door frame
cover (lift up from
bottom legs and pull
down to remove top
from locating tabs.)
Note -
the legs are
held in place by
magnets and may
require gentle prying
to remove.
Tilt door back and check all bolt holes line up. Slide door
sideways to correct where required.
Door should sit flush against the frame located in the
angle support brackets.
Fit all screws loosely. Once all fitted hand tighten. Do not
overtighten screws.
Ensure magnet is fitted to lower section of each side of
door frame
Fit door frame cover trim. Support while fitting to prevent
bending. Locate into top slots then push back against
door frame. Cover trim is held by magnets located at
lower of door frame.
Fit lower trim.