Real Flame ELEMENT 1200, Инструкция по установке и эксплуатации

Страница: 23 / 47

23
Page
Feed power cable through
wall and into wall terminal.
Feed air intake flue pipe
through location spigot
and fit retaining screw
Fit front cover.
Slide flue onto connection
spigot fully. Tighten clamp
fully.
Wipe excess silicon,
visually check connection
to ensure connection is
fully sealed.
Apply an 8mm silicon
bead fully around the
inside of the flue end
(heater connection end)
Fit flue clamp over flue
(loosely).
Cut flue exhaust tube
(hot tube) to length
(Approximately flush with
wall exit). Connection
plate will sit against wall.
Cut Air intake flue.
Ensure ends are burr free
and round, test fit flue will
slide over connection.
Pull flue through approx.
100mm (will be pushed
back once terminal is
fitted).
Push fan terminal into
position. And affix to wall.
Uneven or rough surfaces
may require sealant along
top and side gaps.
Connect power cable
connector. Fit cable clamp
to cable.
Check fan terminal
connections are located
onto terminals and secure.