Real Fires Electronic Range User Guide & Service Manual
4
Remote Control Notes
There are a few things you should know about your Remote Control to keep it
working at its best:
• It uses four AAA batteries. With new batteries the Remote Control will
work from about 8 metres away from the fire.
• When replacing the batteries, replace all four; do not mix old with new.
• Remove the batteries if the fire is not going to be used for extended periods.
• Some fluorescent lights can affect the performance of the Remote Control.
• Avoid dropping the remote or getting it wet.
Remote Control Operation
Point the Remote Control towards the fire and press
the Power Button for about one second. The fire will
then commence the ignition sequence. As the fire is
lighting, press the Flame Control button to the + high
flame. This ensures the fire ignites on high flame.
Always run the fire on high for at least a few minutes
to ensure a quick warm-up of the firebox and flue.
The fire can then be turned down if desired.
The flame can be controlled simply by pressing the
remote Flame Control or – to increase or
decrease the flame.
The electronic Real Fire has a two-speed fan. The fan
is also controlled from the Remote Control by pressing the Fan Control button
+ or – to switch the fan on/off or high/low.
To switch the fire off, press the Power button on the Remote Control.
Auto Off Timer
By pressing the Auto Off Timer button on the Remote Control the fire can be
set whilst in operation for a 30-minute delayed switch-off. The red indicator
light on the Front Panel of the fire will flash when this mode has been activated.
Pressing the Auto Off Timer button a second time will cancel this mode.
Power
Flame
Control
Fan
Control
Auto Off/
Cancel
