RCBS 98941, Инструкция по эксплуатации продукта

Страница: 12 / 116

5. When the display shows C 50, remove the 20 gram weight and add the 50 gram weight to
the platen. When "Stable" is displayed, press the [CAL] key. See Fig. 4 .
6. Now the display will show 50.00g. See Fig. 5 . Remove weight from the platen, and place in
the weight holders. The display will automatically switch to 0.0 GN (grains) and the scale
will beep to confirm calibration is complete.
7. Next place the powder pan on the platen and press the [ZERO] key to zero the weight of
the pan. The display will show 0.0 GN and is now ready to operate. See Fig. 6 .
Notice: During the calibration process, ERROR will be displayed if an incorrect weight is used.
Please use only the calibration weights that are provided with the MatchMaster.
SELECT POWDER TYPE BEFORE DISPENSING
Before start, use number key and [POWDER] key to select powder dispense speed. If dispense
speed is not selected before dispensing, “Err03” will display.
Note: If selected dispense speed dispenses on target but dispense time is long, select the next
higher dispense speed. If the dispense speed selected is fast but causes an overcharge, select
the next lower dispense speed.
AUTOMATIC DISPENSE MODE (Factory Default setting)
This allows powder charges to automatically dispense from the unit once an empty scale pan is
placed onto the unit and the scale is stable. Follow the steps below to use Auto mode:
1. Press [MODE] key and “Auto” will display. Press [GO] to enter setting. Use [4] or [6] to
choose “on” and Press [GO] to set as automatic dispense mode and display shows “Auto”.
2. Enter the desired charge weight and press [GO] key to dispense the first charge.
8
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6