RCBS 98941, Инструкция по эксплуатации продукта

Страница: 11 / 116

Menu
(use keys [2] or [8])
Setting value
(use keys [4] or [6])
(*=default)
Description
Auto on*/oFF Auto dispense
MAtCh on/oFF* Match mode
bLE
see Bluetooth Setting for more details
nAME Composed of 5 digits (0~9)
AB Set bluetooth parameters AB
( default AB = 00)
PoWdE
see pg.14, User Defined Powder Configuration for more details
uSr Configure user defined powder
configuration 06~20
A Powder Size 1~4
B Standard/match mode: 0=match,
1=standard
C Weight unit: 0=gm, 1=gn
D Minimum operation value for large
tube: 1~40
E Expected large tube stop point:
1~99
F Expected small tube stop point:
0~99
G G
1
G
2
Angle and response time for
short trickle: 0,0~9,9
H Expected start point for short trickle:
0~99
I I
1
I
2
Angle and
response time for
short trickle: 0,0~9,9
Sound on*/oFF Buzzer sound
7
CALIBRATION
Always warm up the scale 15-20 minutes before calibration. Always calibrate your scale before
use. This must be done WITHOUT the powder pan on the platen. To calibrate the scale, follow
the steps below:
1. Be sure the powder pan has been removed from the scale platen. When you turn the
scale on, the display will show 99999 across the display for a few seconds and then counts
down to display 0.0 GN (grains mode). Once “Stable” is displayed, the scale is ready to be
calibrated. See Fig. 1 (next page) . Note: The unit will automatically switch to STD (standard)
mode (Match mode "oFF") when the calibration process is initiated.
2. Next please press [CAL] key on the scale. The display will show C 0, and "GM" will be
displayed in the lower right hand corner of the display. See Fig. 2 .
3. When the display shows C 0 and “Stable” shows up, press the [CAL] key again.
4. When the display shows C 20, place a 20 gram weight on the platen and when “Stable” is
displayed, press the [CAL] key. See Fig. 3 .