Getting Into Programming Mode
ENTERING PROGRAM MODE
.
1. Press and hold the
CODE SEARCH
key for at least
3 seconds until a
CODE SET
display message is
seen on the LCD display window.
2. One menu message will be shown one at a time, for
Menu 1 through 13.
In order to access all 13 programming items shown below,
special key press cycle must be performed to get into this
mode (See page 21).
3. Use
UP (
▲
)
key
DOWN (
▼
)
key to scroll up or scroll
down the menu messages to have the desired
message appeared in the display message window.
4. Press
SELECT
to select a desired programming
mode.
Programming Your Device With Code Set
1. Manually turn on the device you want to program.
2. Press and hold the
CODE SEARCH
key until the
remote window displays
CODE SET
.
3. Press the
SELECT
key to enter into the
CODE SET
sequence.
4. Use the Device or
UP (
▲
)
key
DOWN (
▼
)
key to scroll
to the desired device.
(TV, VCR, TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME,
MISC, PHONO, CAB, SAT & VIDEO)
5. After the desired device type is selected, find the four-
digit code for the corresponding device in the code lists
starting at page
9
. Enter the four-digit number for the
desired setup code.
6. Once the four-digit code has been entered press the
SELECT
key to accept the desired setup ID code. The
LCD display window will show a message displaying
SUCCESS
or
NOT FOUND
to verify the ID code.
NOTE: If the message displays
NOT FOUND
return to step 5
and repeat the steps again.
7. To exit the
SETUP CODE
, press
CLEAR
key.
EXIT
SETUP
will be displayed and the remote exits code
setup programming.
8. With your device on , press the
CH+
(Channel Up). Some
devices may not respond to
CH+
. For those devices
press the
ON•OFF
key. If the device responds, no further
programming is required.
NOTES:
• Press the
CLEAR
key at any time to exit the programming
mode. An
EXIT SETUP
message will appear confirming that
no new codes have been entered.
OR
OR
OR
5
RCU810_MANUAL.QXD 1/7/02 11:49 AM Page 6
