Deleting A Macro Key Sequence
1. Press and hold the
CODE SEARCH
key until the remote
window displays
CODE SET
.
2. Step through the programming menu using the
UP (
▲
)
key or
DOWN (
▼
)
key for
KEY MACRO
,
then press the
SELECT
key.
3. Once the
SELECT
key is pressed a
SEL MACKEY
message will display for you to input a Macro Key.
NOTE: If the entered key is a invalid Macro Key, a display
message
INVALID
will be shown and the remote will
stay in Macro programming mode until a valid Macro
Key is entered.
4. Press the Macro Key (
M1, M2 or M3
) to enter into the
correct sequence. The display message
ENTER SEQ
will be shown.
5. Press and hold down the
SELECT
key for 3 seconds to
complete the deleting sequence.
The SELECT key must
be pressed and held down for at least 3 seconds to
exit the sequence.
6. The remote will then display the message
SUCCESS
,
followed by the message
EXIT SETUP
and return to its
normal operation.
NOTES:
• Press the
CLEAR
key at any time to exit the programming
mode. An
EXIT SETUP
message will appear and the remote
will return to its normal operation.
• If about 30 seconds passes before a key is pressed, the LCD
display window will stop transmission to conserve battery life.
If this occurs, restart from step 1.
To delete a Macro key sequence, either overwrite it with a new key on the same key, or use the
procedure below.
Hold For 3 Seconds
18
RCU810_MANUAL.QXD 1/7/02 11:49 AM Page 19
