1. Press and hold the
CODE SEARCH
key until the remote
window displays
CODE SET
.
2. Step through the programming menu using the
UP (
▲
)
key or
DOWN (
▼
)
key for
IR DELETE
,
then press the
SELECT
key.
3. Choose the desired device key then press the
SELECT
key to continue to delete the learned data.
4. Press the function key to be deleted on the RCU810
remote control in which you will delete the function that
has been stored.
5. If the key is a valid one, the learned data in a key has
now been deleted, followed by display message
DELETED
will be shown.
6. Repeat steps 4 and 5 to delete more functions.
7. When the selected functions are deleted press the
CLEAR
key to exit the
IR DELETE
programming
mode. The LCD display window will show a message
displaying
EXIT SETUP
and return to original
operation mode.
NOTES:
• Press the
CLEAR
key at any time to exit the programming
mode. An
EXIT SETUP
message will appear confirming that no
new codes have been entered.
• If about 30 seconds passes before a key is pressed, the LCD
display window will stop transmission to conserve battery life.
If this occurs, restart from step 1.
To delete a learned key sequence, either overwrite it with a new key, or use the procedure
below.
Deleting A Learned Key Sequence
Or Any Other Function
That Was Learned.
15
RCU810_MANUAL.QXD 1/7/02 11:49 AM Page 16
