The RCU1010RF remote can control up to nine components. In order for the RCU1010RF to control your
components (TV, VCR, PVR/DVR, DVD, etc.), you must program it with the corresponding code entry
from the Code Lists. This enables the remote to control your component with the proper commands. If
your TV, VCR, DVD, or satellite receiver is an RCA, ProScan or GE brand, the RCU1010RF may not need
any programming to control it.
To program the remote with the codes for your components, you can use one of
three
methods: Code List
Entry, Code Search or Code Autosearch.
Use the Code List Entry method first, as this is the quickest and
easiest method. The Code Search method may require up to 300 keypresses, and the Code Autosearch
may take some time to cycle through all available codes.
During all code entries, the remote control unit must be pointing at the component you are programming.
While programming your remote, you may wish to extend the LCD touchscreen display time (see LCD
Touchscreen Display Time section on pgs. 27-28).
Code Entry
You can enter codes in your RCU1010RF from the Code Lists using the
SETUP
key. (Refer to the Code Lists
of the most popular brands at the end of this User’s Guide.) When you enter a valid code for any given mode
(e.g., when you enter a valid code for a TV), the default key labels are displayed on the touchscreen, and any
Code List Entry
10
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 10
