18
1. Gather all the remotes that you want to learn and have them all
lined up on a flat surface before going into the Learn IR Mode.
2. Place the first original remote in the Learning position (see
Learning Tips section on pg. 17). Point the top of the original
remote at the base of the RCU1010RF so the IR LED on the
original remote is in line with the RCU1010RF Learn sensor,
located at the bottom of the remote. The remotes should be
positioned 2-3 inches apart.
3. If the original remote is a universal remote, you must press
the component key on that remote to select the desired mode
before proceeding with Learning. For example, pressing the
VCR
key on your original universal remote will allow your
RCU1010RF to learn from that component mode. If the
original remote is a dedicated remote, e.g., a DVD remote
only, this step is not needed.
4. Press and hold the
SETUP
key on the RCU1010RF’s rubber
keypad for 2-3 seconds until the LED indicator light remains
on and the touchscreen shows the Code Setup Mode? Screen.
5. Release the
SETUP
key.
6. Press and release the LCD
LEARN
key. The Learn IR Mode?
Screen is displayed.
7. Press and release the desired component key (
TV
,
VCR
,
SAT
,
AUX
,
PVR/DVR
, etc.). The Learn IR Key? Screen is
displayed.
8. Press and release the LCD key or the rubber key on the
RCU1010RF that you wish to use to store the Learned
commands. The Learning Please Wait Screen appears.
Note:
You cannot learn any commands under the LCD
LEARN
, LCD
MACRO
,
SETUP
,
BACKLIGHT
or any LCD
component keys.
9. Press and hold the original remote key you want to transfer to
the RCU1010RF until the Success Screen, followed by the
Learn IR Key? Screen, appears in the display. This process can
take 2-3 seconds to complete.
10. Release the original remote key. If there is a problem during
the Learning process, the LCD displays the Learning Error
Screen for three seconds but still remains in the Learning
Setup Mode. If this occurs, try adjusting the distance between
the remotes slightly and repeat from step 8.
11. Repeat steps 8-10 for other keys to be learned.
12. When all the original remote commands have been learned,
press and release the
SETUP
key. The display shows the
Learning Completed Screen, followed by the Learn IR Mode?
Screen. At this point, you can press and release the next
component key for additional remotes you want the
RCU1010RF to learn and repeat steps 7-10. Remember: Each
time you learn from a different component, you must put
your original remote in that component mode. If the original
remote is a dedicated remote, e.g., a DVD remote only, this
step is not needed.
13. The Learning process is now complete. To exit the Setup
Mode, press and release the LCD
EXIT
key, followed by the
LCD
OK
key on the Exit Setup Screen.
Note:
If the LCD
EXIT
key does not respond, press and
release the
SETUP
key repeatedly until the Exit Setup
Screen appears.
Learning Commands (continued)
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 18
