33
PROBLEM
The touchscreen does not show anything when
you touch it or when you press the
SETUP
or
BACKLIGHT
keys.
The remote does not operate your audio
or video components.
You have problems programming a TV/VCR
or TV/DVD combination unit.
Your VCR is not recording.
You have trouble changing the channels
on your TV.
The LCD
SELECT
key is not responding.
The LCD
EXIT
key does not respond during
the MACRO or LEARN process.
The IR Learning or SmartMacro processes
cannot be completed successfully.
SOLUTION
•
Replace the batteries with four new
AAA alkaline batteries.
•
Check to make sure the batteries are
properly installed.
•
Try all code programming procedures
with all the codes from the appropriate
part of the Code Lists.
•
Make sure the remote is in the correct mode
for the component you are attempting to
control (TV, VCR, DVD, etc.). (
Note:
Use
the VCR Mode to operate a PVR/DVR.)
•
Make sure the remote is pointed at the
component being operated.
•
Try the VCR or DVD code for your brand.
Some combination units, however, may
require both a TV and a VCR or DVD code
for full operation. To do this, program the TV
code under the
TV
key and the VCR or DVD
under the
VCR
or
DVD
key.
•
As a safety feature on your remote, you
must press the LCD
RECORD
key twice.
•
If your original remote requires the
ENTER
key
to be pressed after a channel is selected, press
the LCD
ENTER
key on the RCU1010RF
to select the channel.
•
Try using the LCD
MENU
,
GUIDE
, or
ENTER
key to make the selection.
•
Press and release the
SETUP
key repeatedly
until the Exit Setup Screen appears. Press the
LCD
OK
key.
•
Replace batteries in the RCU1010RF and the
remote from which you are trying to learn.
•
The distance between the remotes should
be approximately 2-3 inches.
•
Do not conduct the Learning process near
an incandescent lamp.
•
The memory capacity is full (20 Learned
commands for each of the nine modes).
•
The original remote may not be compatible
with the Learning procedure.
Troubleshooting
The LED indicator light on the RCU1010RF
remote illuminates when you press a key,
but the red light inside the transmitter
does not illuminate.
•
Make sure the Remote Sender Cone is plugged
into an electrical outlet.
•
Make sure you are operating the remote
control unit within 100 feet (30.48 meters)*
of the Remote Sender Cone.
•
Extend the antenna all the way up on the
Remote Sender Cone or reposition the antenna
for better reception.
* Range may vary based on home construction
RCU_1010_RF_IB_RevA.qxd 9/24/03 10:31 AM Page 33
