RAZBAM Metroliner III SA227-BC, Руководство по эксплуатации самолета

Страница: 70 / 93

RAZAIR ‐ A1 ‐ METRO ‐ III ‐ AFM ‐ 001
2 ‐ 18

MSG: The Message annunciator flashes when there is a new message to view. If there are multiple messages
that you have not yet viewed, the light continues to flash until all messages have been viewed.

WPT: The Waypoint annunciator light alerts you to waypoint arrival. The light will flash when approaching the
active waypoint.

PTK: Parallel track annunciator light. Not available, only turns on during self ‐ test.

HLD: The Hold annunciator light alerts the pilot that Active Flight Plan is suspended at the current Active
Waypoint.

APR: The Approach annunciator light turns on when there is an approach loaded and active.
NAV MODE
The NAV mode is the most frequently used mode in the GPS. Once you had loaded a flight plan, the NAV mode provides
information needed to navigate the aircraft through the selected route. In NAV mode each display line has eight data
pages available that can be navigated by using the outer and inner knobs.
TOP LINE
The data pages displayed on the top line, starting with the default page and rotating the outer knob clockwise, are:

TO ‐ Waypoint, Bearing, Distance and ETE (estimated time en route).

TO ‐ waypoint, ETE and ETA (estimated time of arrival in Zulu time).

Heading, TAS (True Airspeed), and wind.

Heading, Ground Track and Drift Angle.

Current Track and recommended altitude.

DTK (Desired Track), Fly left or right to correct XTK (cross track error), XTK error.

MSA (Minimum Safe Altitude) and MESA (Minimum En route Safe Altitude).

TKE (Track Error), DTK and Distance to Waypoint.
BOTTOM LINE
The data pages displayed on the bottom line, starting with the default page and rotating the inner knob clockwise, are:

CDI, Ground Track and Ground Speed.

Current Track and recommended altitude.

Heading, TAS, and wind.

Heading, Ground Track and Drift Angle.

MSA and MESA.

TO ‐ waypoint, ETE and ETA.

DTK, Fly left or right to correct XTK, XTK error

Advisory Waypoint range and bearing.
WPT MODE
To waypoint mode displays waypoint data. It is also possible to change the current waypoint by clicking on the DIRECT ‐
TO function key. There are two mode pages in WPT Mode:
MODE 1 (Flight plan Mode)
Current flight plan waypoint data is displayed as follows: