www.rayteccctv.com
2
Raytec Global Tel: +44 (0) 1670 520055
Raytec Americas Tel: +1 613 270 9990
Wiring
The lamp is supplied with a waterproof Ethernet connection (RJ45) on a flying lead and a
Multi-core auxiliary power and control cable.
If using PoE, connect an Ethernet cable (category 5 or better) between the Power Sourcing
Equipment (PSE) and the lamp. Ensure that the PSE is sufficiently rated to power the Vario
IP POE device. Requirements are as follows:
VARIO IP PoE Unit
PoE Requirement
VAR-IPPOE-w4-1, i4-1, i4-1-c
IEEE 802.3at (HP PoE) 25.5W
VAR-IPPOE-w8-1, i8-1, i8-1-c
4-pair POE >50W
When using PoE the CAT5 cable is both the power and data connection for the lamp. The
maximum Ethernet cable length is 100m (328’) without boosting the signal.
Ensure you make a waterproof connection to the RJ45 as shown below. Ensure the
connector is waterproof and sealed after the connection is made.
To lamp RJ45-RJ45 connector To Network
If using Auxiliary Power, connect
24V DC
to the red (+ve) and black (-ve) cables of the
multicore auxiliary cable. In this case the Ethernet cable is a data connection only and
supplies data signals to/from the lamp.
Connect external input trigger and external output as required
– see table below
Please Note :
To maintain the environmental integrity of the product, as part of the
installation, the multicore auxiliary cable must be terminated appropriately regardless of
which cores are being used.
Colour
Description
Wire Gauge (AWG)
w8-1, i8-1, i8-1-c
w4-1, i4-1, i4-1-c
Red
+ve Auxiliary Power
18
22
Black
-ve Auxiliary Power
18
22
Orange
External Input (Only if TTL:
+ve)
22
22
Purple
External Input (Only if TTL:
GND)
22
22
Yellow
External Output
22
22
White
External Output
22
22