Raytec PULSESTAR VTS Series, Руководство по установке

Страница: 32 / 38

Clear configuration
CL
This command clears the configuration. The results of the RW , RT , RE ,
and TT commands are all cleared.
Enable Ethernet messages
GTm
Where:
m
= 0 to disable Ethernet messages
= 1 to enable Ethernet messages
When Ethernet messages are enabled, any error reports are sent to the
most recent UDP or TCP addresses from which a command has been
received. Messages are typically in the following form:
Evt1,e
Where (for example):
e – event value; see Section 11.2, Event codes and Section 11.3,
Error codes for the range of codes that may be reported.
Clear any errors
GR
If Ethernet messages are not enabled, the last event or error number can be
read by this command.
If there was a lighting error, the VTS resumes normal operation.
The reply is in the same form as the GT command above. If there are no
outstanding events or errors, then only the prompt > is returned.
Set/Clear the web-page password
EY
EY asc1, asc2, asc3, asc4, asc5, asc6
This command sets the password required to access the webpages. If EY
is entered on its own, then the password is cleared.
There are six optional parameters, which are decimal ASCII values for a
password from one to six letters. A value of 65 is
‘A’, 66 is ‘B’, and so on to
90 is ‘Z’.
2 8