Raytec AR10, Монтаж и установка

Страница: 7 / 15

Raytec Americas: +1 613 270 9990 • ushazsales@raytecled.com
Raytec Ltd reserve the right to change specifications without prior notification or public announcement.
Version 1
www.raytecled.com
1277-D
-0002
SPI-AR
4.3in
108.15mm
2.3in
59mm
0.27in
6.76mm
0.27in
6.8mm
1.7in
44mm
2.8in
70mm
Installation Steps
Yoke Mount Installation (Ordered Separately)
Step 1.
Step 2.
Step 5.
Step 6.
Step 7.
Step 3.
Step 4.
This SPX-BKT-AR-YM kit is intended for use with UL Listed AR luminaire as marked on the luminaire nameplate.
Accessory Package Contents
Refer to alternate instructions if using Conduit, Hook, Pole or Wall Mount
Inspect shipping package and contents to ensure no damage has occurred during
shipping. Discard surface/ceiling mounting bracket provided with AR luminaire.
Remove 4 x M6 bolts from supply side of luminaire and disard.
Install suitable wiring system to the conduit opening per CEC/NEC requirements for
the specific location of install.
NOTE: To aid in assembly and protection against ingress use of a petrolatum or soap
thickened mineral oil based thread lubricant/sealant is necessary.
Un-used conduit opening must be plugged to maintain the integrity of the enclosure.
Mount luminaire assembly to desired location using 4x 1/4-20 OR M6 Screws or Bolts
(Not Provided).
Adjust and aim luminaire to desired position. Torque hardware nuts to 9 N-m (80 in-lbs).
Resume installation instructions provided with luminaire.
(STEP 4 in AR Installation Instructions provided with Luminaire)
Loosely assemble Yoke mount with carriage bolts on inside and washers and
nuts on the outside.
NOTE: Depending on which mounting hole is used in the curved slot, the
luminaire may be configured for an upward or downward adjustable swing.
Thread installed wiring through openings in yoke mount cheek plate and yoke
mount bracket. Mount yoke assembly to luminaire using 4x M6 Socket Head Cap
Screws and Washers (Provided). Torque fasteners to 5 Nm (45 in-lbs).
SPX-BKT-AR-YM QTY PART NAME
1
YOKE MOUNT A
1
YOKE MOUNT B
1
CHEEK PLATE
4
1/4-20 HEX NUT
4
1/4" FLAT WASHER
4
1/4-20 x 0.5in CARRIAGE BOLT
4
M6 x 25mm HEX HEAD CAP SCREW
Step 3
Step 5