Raypak X94, Инструкция по установке и эксплуатации

Страница: 38 / 52

38
Low Temp Lockout
Use the UP and DOWN buttons to enable or disable
the low water temperature lockout function. Low Temp
Lockout will inhibit the pool heater from firing if water
temperature is sensed below 36ºF (2.2ºC). The X94 is
designed to operate with low inlet water temperatures
under start up conditions, but it is not intended to main-
tain temperatures below 50ºF (10ºC) or operate with
water temperatures below 36ºF (2.2ºC). Disabling the
Low Temp Lockout is not recommended as operation
with water temperatures below 36ºF (2.2ºC) will
adversely affect heater life.
EcoNet Address
Use the UP and DOWN buttons to select the EcoNet
Address, 1 to 16, for the heater when there are multi-
ple pool heaters on an EcoNet network.
Set Factory Defaults
Use the UP and Down buttons to select Yes or No.
Selecting Yes will return all installer and schedule set-
tings to factory defaults.
Control Lockout
The heater is equipped with a Control Lockout feature
to prevent unauthorized tampering or adjustment of
the control settings. To lock out the controls, press the
DOWN button and MODE button for 5 seconds.
Choose a three digit PIN, using the UP and DOWN
buttons to select the digits and the MODE button to
lock in selections. Confirm your selection and record
your PIN.
To unlock the controls, press any button to bring up the
Enter PIN menu. Enter the PIN that was used to lock
the control. Note that power cycling will not clear the
lockout. Successfully unlocking the control will display
“Lockout Cleared.” Failure to enter the correct PIN will
display “Invalid PIN.”
In the event that the user-selected PIN is lost or does
not clear the Control Lockout, use the Program Button
to access the Installer Setup Mode to Set Factory
Defaults. This will clear the PIN and allow normal
operation and selection of a new PIN if desired. See
the Installer Setup Mode directions on page 36 for
details.
The digital thermostat models are programmed to dis-
play a variety of status and diagnostic messages,
depending on the operating conditions.
The following heat status and error condition mes-
sages are displayed in Pool, Spa, and Remote modes.
The heat status messages are displayed only if there
are no active fault conditions.
NOTE: Set Factory Defaults will reset all Installer
Setup Mode items, temperature settings and sched-
ules to factory defaults. Prior to resetting, verify that
all current data is recorded on the Control Settings
form on page 51 of the manual prior to using the Set
Factory Defaults function.
NOTE: The LCD temperature display may not
agree with the temperature reading of your pool or
spa thermometer. The heater reads the water tem-
perature at the inlet to the heater. Due to the circula-
tion characteristics of any pool or spa, the water tem-
perature at the inlet to the heater may differ from that
observed at a given location in the pool or spa.
Display Condition
WPS Stuck Closed
Valves not operated because the water flow switch is closed and Valve Chng Delay is
enabled
Water Sw Open
Heat not running because the water flow switch is open
Valve Chng Delay Pump/Heat shut off because of valve switching
High Heating Second stage heat is running with EXT HEAT Aux mode
Heating Heater is operating
Spark Ignition control is running spark
Post Purge Ignition control is in the post-purge period
Pre-Purge Ignition control is in pre-purge or inter-purge
External Heat External device is running 1st stage instead of Gas Ignition (EXT HEAT Aux mode)
No Demand Heat demand is satisfied
STATUS AND DIAGNOSTICS