Raymarine SPX-5, Инструкция по установке и настройке

Страница: 13 / 76

Chapter 1: Installation and system overviews 5
Tools and equipment NOT supplied
You will need to supply the following equipment and tools:
Tools:
• Cross-head/pozi-drive screwdriver.
• Pliers.
• Power drill (cordless recommended).
• Bearing puller to remove steering wheel.
• Tape measure (metric/imperial).
• Hammer and center punch.
• Pencil, masking tape.
• Spanner (Wrench) to fit wheel nut.
• Washing-up liquid (to lubricate the spokes).
• Hacksaw.
• Power/battery Drill.
• 4 mm + 6 mm drill bits (supplied).
• 3 mm allen key (Hex key, supplied).
Cables / equipment
• Power cable and fuse/breaker.
• Additional data cables (e.g. for connection of GPS or chartplotter).
• Grounding braid.
Optional equipment
• Bulkhead fitting kit, Raymarine part number E15017, if your wheel is bulkhead or
box pedestal mounted.
• Additional spoke clamp, Raymarine part number A18089. Enables you to fit an
extra clamp to a 4-spoke wheel, for esthetic reasons.
1.5 Create a schematic diagram
As part of the preparation for installing your SPX-5 Wheel system, we recommend
that you create a schematic diagram representing the system you want to install. This
will help ensure that you install a safe optimum system, and so is particularly
important if you intend connecting your autopilot to other electronic equipment.
The schematic diagram should include:
•
Location of all components. See page v and page 7 for EMC guidelines that may
affect the location of specific components.
• Connectors, cable types, routes and lengths.
When you have completed the schematic diagram, you are ready to begin installing
the SPX-5 Wheel system.
87074_2.book Page 5 Wednesday, November 21, 2007 3:55 PM