Raymarine SPX-5, Инструкция по установке и настройке

Страница: 24 / 76

16 SmartPilot X-5 Wheel Installation & Setup Guide
CAUTION: Pedestal mounted compass
If you use slot 2 and you have a pedestal-mounted compass, the drive
motor may affect compass readings.
Pedestal bracket – length and position
Note:
If you are replacing an existing 4000 wheel drive, you need to: remove the old pedestal
bracket, cut the new bracket pin to the correct length (see steps 2 and 3 below), then secure it in
the standard orientation using the existing pedestal holes.
1. Fit the wheel onto the pedestal, tighten the wheel nut to hold the wheel in place,
and engage the wheel drive’s clutch. Either:
•
lock the wheel in position with the appropriate slot centered at the bottom of
the wheel
or
• have an assistant hold the wheel in position so you can locate the bracket
correctly.
2. Measure dimension A – the distance between the front of the pedestal and the
rear edge of the drive’s front cover (see diagram).
Note:
You may find it easiest to hold the bracket below the wheel drive and mark dimension A
directly on the pin.
D10638-1
Slot 2 installation:
motor tube at
top left
Slot 1 installation:
motor tube at
bottom right
Slot 1
Slot 2
87074_2.book Page 16 Wednesday, November 21, 2007 3:55 PM