Raymarine SPX-5, Инструкция по установке и настройке

Страница: 47 / 76

Chapter 3: Commissioning & setup 39
Carry out an AutoLearn as follows:
1. Ensure you have sufficient sea room to complete the AutoLearn:
2. Access the AUTOLEARN screen in Seatrial calibration:
i. From Standby mode, hold down
standby
for 2 seconds, then press
disp
twice
to see the
SEATRIAL CAL
screen.
ii. Press
auto
to enter Seatrial calibration, then press
disp
four times to see the
AUTOLEARN screen.
3. Prepare to start the AutoLearn:
• Steer straight ahead (rudder centered) and motor the boat at typical cruising
speed.
• If conditions are not calm, head into the wind and waves.
4. When you are ready to start the AutoLearn, press
+1
then
auto
.
At least 0.25 nm (500 m) of clear sea space
At least 0.04 nm (100 m)
of clear sea space
D10544-1
1 minute
(approximately)
Wind
2 sec
x2
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
x4
D10545-1
AutoLearn in progress
Prepare for AutoLearn
Start
AutoLearn
Enter Seatrial calibration
CHECK!
Before proceeding, ensure
you have sufficient clear
sea space
87074_2.book Page 39 Wednesday, November 21, 2007 3:55 PM