Raymarine SmartPilot SPX-10, Руководство по установке

Страница: 39 / 50

The connector panel is accessed by removing the cover.
1.
2.
A B
D10449-2
• A — Unlock cover panel
• B — Lock cover panel
After installation you should:
1. Perform an initial power-on test of the system.
2. Commission the system including calibration of the compass
and setup of the autopilot characteristics.
Important: Before using the autopilot system it is essential that it
is properly commissioned in accordance with the commissioning
instructions provided.
4.3 Initial checks for the autopilot
installation
These checks should be carried out after installation, and prior to
the commissioning of the autopilot system.
1. Switch on power to the autopilot system and associated
equipment.
• Course computer
• Autopilot controller
• SeaTalk and/or SeaTalk ng data bus (if these have their own
separate supply).
2. Check that the autopilot controller powers up. If the display is
blank press and hold the Power key for 1 second.
3. Check the display for error messages that could indicate a
problem with the installation.
For assistance with diagnosing faults:
• Refer to the troubleshooting information supplied with the
product, or
• contact Raymarine customer support.
Installation 39