Raymarine RAY50, Инструкция по установке и эксплуатации

Страница: 70 / 116

8.5 Private channels
The radio may be able to receive additional Private
channels depending on the country it is used in and
whether the appropriate licenses are held.
The following Private channel sets can be selected:
• None
• Belgium
• Denmark (pleasure)
• Denmark (fishing)
• Finland (pleasure)
• Finland (fishing)
• Holland (Netherlands)
• Norway (pleasure)
• Norway (fishing)
• Sweden (pleasure)
• Sweden (fishing)
• UK
Selecting a private channel set
You can select the set of private channels you want
to use.
From the Channel set-up menu: Menu > Set-up
> Channel set-up .
1. Select Private channels .
The list of private channel sets is displayed:
2. Select the required private channel set.
8.6 Automatic Transmitter
Identification System (ATIS) and
Marcom-C mode
ATIS is a European system used on some inland
waterways.
VHF radios operating in an ATIS region must be
programmed with a unique ATIS number; this can be
obtained from the relevant licensing authority. The
ATIS number is attached as a digital signal at the
end of each transmission and identifies you to the
relevant authorities who monitor the system.
When operating in ATIS mode, some of the products
features are not available:
• Use of DSC functions is not permitted in ATIS
regions.
• Watch modes are not permitted in ATIS regions.
• Channel scanning is not permitted in ATIS regions.
• ATIS regulations restrict the transmit power to 1
watt for the following channels: 6, 8, 10, 11, 12,
13, 14, 71, 72, 74 and 77.
You can enable or disable ATIS using the menus
(except on Marcom-C configured units).
Marcom-C mode
Marcom-C mode is a restricted radio configuration
for VHF operators with a Marcom-C license. This
is applicable to radios operated exclusively in
European inland waterways using the ATIS system.
A Marcom-C VHF radio has the ATIS permanently
enabled. You will not be able to disable ATIS
operation. Marcom-C operation is set by the dealer
at point of sale. If you wish to enable or disable
Marcom-C mode, you must contact your Raymarine
dealer.
For further information please contact Raymarine
technical support.
Enabling and disabling ATIS mode
ATIS is a European system used on some inland
waterways. ATIS must be enabled and a unique
ATIS ID entered in order to use ATIS mode.
From the Main menu.
1. Select
Set-up .
2. Select ATIS set-up .
3. Select ATIS .
4. Select On to enable ATIS mode or Off to disable
ATIS mode.
With ATIS mode enabled the radio’s region will
be fixed to the INT (international) frequency band
and the following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain
channels
Once ATIS has been enabled an ATIS ID must be
entered.
70
Ray50 / Ray60 / Ray70