Raymarine RAY50, Инструкция по установке и эксплуатации

Страница: 7 / 116

Chapter 1: Important information
Safety notices
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details,
and refer to the separate warranty document packed
with your product.
Warning: Product installation and
operation
This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
Warning: Potential ignition source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room
or near fuel tanks).
Warning: 12 Volt dc only
This product must only be connected to a
12 volt dc power source.
Warning: Positive ground systems
Do not connect this unit to a system which
has positive grounding.
Warning: Switch off power supply
Ensure the vessel’s power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
Warning: Chassis grounding
Do NOT ground this product using the
chassis ground terminal.
Grounding this product to a vessel’s RF
ground may cause galvanic corrosion.
Warning: Antenna isolation
To prevent galvanic corrosion your
antenna must be isolated from any vessel
metalwork using a suitable insulated e.g.
plastic, mounting bracket.
Warning: FCC Warning (Part 15.21)
Changes or modifications to this
equipment not expressly approved in
writing by Raymarine Incorporated could
violate compliance with FCC rules and
void the user’s authority to operate the
equipment.
Warning: Maximum Permissible
Exposure
Failure to observe these guidelines
may expose those within the maximum
permissible exposure (MPE) radius to
RF radiation absorption that exceeds the
FCC MPE limit. It is the radio operator’s
responsibility to ensure that no one comes
within this radius.
For optimal radio performance and
minimal human exposure to radio
frequency electromagnetic energy, make
sure the antenna is:
• connected to the radio before
transmitting
• located where it will be away from
people
• located at least 1.5 meters (5 feet) from
the radio’s main unit
Caution: Power supply protection
When installing this product ensure the
power source is adequately protected
by means of a suitably-rated fuse or
automatic circuit breaker.
Caution: Perform regular radio
checks
Perform regular radio checks when using
your vessel, as recommended in radio
training and certification schemes and
radio equipment rules of use.
Caution: Ensure proper radio use
Under no circumstances should a DSC
distress alert be sent from your radio for
test purposes. Such action is a violation
of rules of use for radio equipment, and
can result in heavy fines.
Important information
7