Raymarine G-Series system, Инструкции по установке и пусконаладке

Страница: 85 / 128

85 Chapter 8: Commissioning
2. Note the position of the object on the radar display. If the target
is not under the Ships heading marker (SHM), there is an align-
ment error and you will need to carry out bearing alignment
adjustment.
To adjust the bearing alignment
With a radar window active select the bearing alignment menu:
From the menu:
1. Press the BEARING ALIGNMENT softkey.
2. Use the rotary control to place the selected target under the
SHM.
3. Press OK when complete.
Parking settings (open array scanners)
To ensure the scanner parks (rests) in the correct position when
rotation stops, you may need to adjust the radar offset angle.
To adjust radar parking settings
From the Radar setup menu (radar in standby mode):
1. Select the PARKING OFFSET option, then adjust the offset
angle required to park the radar so that the antenna comes to
rest facing forward (you should see the Raymarine logo wording
from the front of the boat) when you place it in either standby or
switch it off.
2. Press OK when complete.
8.4 GPS checks
The GPS is required to show your boat position on the chart. You
can set up your GPS and check its status using the GPS status
icons and the GPS Status page of the Setup menu.
Check the GPS Status icon
This is located in the top right hand corner of the screen.
If NO FIX is displayed refer to the GPS status page (below) and
Troubleshooting section on
page 95 .
GPS Status page
D10343-1
MENU
RADAR SETUP
BEARING ALIGNMENT
D10346-1
D10344-1
MENU
GPS STATUS