10
LifeTag Installation & Commissioning Guide
Fitting procedures
When you are satisfied that your LifeTag system will give satisfactory coverage aboard your boat:
• Fit the Base Station and Alarm buzzer, as described in
Figure 14
and
Figure 15
respectively, then
connect up your system. A summary of system connections is given in
Figure 16
.
• Fit one of the non-rechargeable, lithium CR2 3V batteries into each Tag as detailed in
Figure 10
.
Base Station
Before you permanently install a Base Station, carry out a site survey (as detailed on
Page 6
) to ensure
you are fitting it to give satisfactory coverage.
Figure 14 - Fitting Base Station
2.
1.
Mark holes for the fixing screws
Remove cover
6.
Replace cover
5.
D8971-1
1
2
4.
Countersink the pilot holes to
prevent damage to the mounting
surface
Use two No. 6 screws to secure the
Base Station to the mounting surface
3.
Drill two
7/64
inch (2.5 mm) pilot
holes for the fixing screws
87064_3.book Page 10 Friday, July 28, 2006 9:32 AM