LifeTag Installation & Commissioning Guide
13
ii. Wait 15 seconds, then hold down the Tag button for a further 5 seconds.
Note:
You can cancel an alarm from any active Tag within range of the Base Station.
Tag registration & de-registration
Registering a Tag
Tags supplied with a Base Station as part of a LifeTag system are factory-registered with that Base
Station, so you do not have to carry out a registration procedure with these.
However, if you have obtained any Tags separately (e.g. if you have bought extra Tags), THEY WILL
NOT WORK WITH YOUR BASE STATION until you have registered them with the Base Station.
Important
You must complete the Tag registration procedure within one minute of switching on
power to the Base Station.
After the Base Station has been switched on for 1 minute, the alarm
‘chirps’ to indicate the end of the Tag registration period.
4. With the boat moored alongside, take each
Tag away from the boat and note the maxi-
mum distance from the Base Station at which
an alarm is initiated.
This distance will be
significantly reduced in real MOB situa-
tions, where the Tag is submerged.
5. Cancel the alarm. To do this:
i.
Hold down a Tag button for 5 seconds, to
silence the alarm.
To register a Tag:
1. Bring the Tag you want to register, near to the Base
Station, then switch on the power to the Base Sta-
tion.
2. Press and release the Tag button. Check that the RED
indicator lights constantly.
D9037-1
12 V dc
D9038-1
RED LED
Lit constantly
D9040-1
87064_3.book Page 13 Friday, July 28, 2006 9:32 AM
