– At least 1 m (3.3 ft) from any equipment transmitting or cables carrying radio signals e.g. VHF
radios, cables and antennas. In the case of SSB radios, the distance should be increased to 2
m (6.6 ft).
– More than 2 m (6.6 ft) from the path of a radar beam. A radar beam can normally be assumed to
spread 20 degrees above and below the radiating element.
• The product is supplied from a separate battery from that used for engine start. This is important
to prevent erratic behavior and data loss which can occur if the engine start does not have a
separate battery.
• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in the installation manual.
Note:
Where constraints on the installation prevent any of the above recommendations
, always ensure
the maximum possible separation between different items of electrical equipment, to provide the
best conditions for EMC performance throughout the installation.
RF interference
Certain third-party external electrical equipment can cause Radio Frequency (RF) interference with
GNSS (GPS), AIS or VHF devices, if the external equipment is not adequately insulated and emits
excessive levels of electromagnetic interference (EMI).
Some common examples of such external equipment include LED lighting (e.g.: navigation lights,
searchlights and floodlights, interior and exterior lights) and terrestrial TV tuners.
To minimize interference from such equipment:
• Keep it as far away from GNSS (GPS), AIS or VHF products and their antennas as possible.
• Ensure that any power cables for external equipment are not entangled with the power or data
cables for these devices.
• Consider fitting one or more high frequency suppression ferrites to the EMI-emitting device. The
ferrite(s) should be rated to be effective in the range 100 MHz to 2.5 GHz, and should be fitted
to the power cable and any other cables exiting the EMI-emitting device, as close as possible to
the position where the cable exits the device.
Compass safe distance
To prevent potential interference with the vessel's magnetic compasses, ensure an adequate
distance is maintained from the product.
When choosing a suitable location for the product you should aim to maintain the maximum possible
distance from any compasses. Typically this distance should be at least 1 m (3.3 ft) in all directions.
However for some smaller vessels it may not be possible to locate the product this far away from a
compass. In this situation, when choosing the installation location for your product, ensure that the
compass is not affected by the product when it is in a powered state.
GNSS (GPS) location requirements
In addition to general guidelines concerning the location of marine electronics, there are a number of
environmental factors to consider when installing equipment with an internal GNSS receiver.
Mounting location
• Above Decks (e.g. open air) mounting: Provides optimal performance. (For equipment with
appropriate waterproof rating.)
• Below Decks (e.g. enclosed space) mounting: Performance may be less effective and may require
an external antenna or receiver mounted above decks.
25
