Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-A6000D~10000D
38
5.3.2 Emission external control
When both A1 and A3 of xP1 are set high, the laser is in the internal control mode, and the light
output is controlled by the computer software's light on button or by communication sending
"EMON" to control the light output, and "EMOFF" to control the light off; When A1 of xP1 is set
high, A3 is suspended or set low, the laser is in the external control mode, and the output light is
determined by the high and low levels of A2, xp2-1 and PIN 2 MOD signals of xP1.
5.3.3 Red light control
When both A1 and A3 of xP1 are set high, the laser is in the red light internal control mode, and
the red light is controlled by the computer software red light button or communication to send "ABN"
and "ABF" used to control the ON and OFF of the red light; When A1 of xP1 is set high, A3 is
suspended or set low, the laser is in external control mode, and the red light is controlled by A5 of
xP1.
The red-light module in the laser works by means of communication, so there is a time delay of
at least 10 MS when the red light is turned on and off;
When the red light is on, the laser cannot be set to ready. Only when the red light is off, can the
laser be ready.
5.3.4 Programming mode
When A1 of xP1 is set high and a8-a14 is not 0, the laser is in programming mode. At this time,
the output light of the laser is controlled by A2 of xP1, and the output wave of the laser is determined
by the edited wave.
6 Wiring diagram and operation steps
