Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-A6000D~10000D
11
3.2 Installation rules
a) Place the laser horizontally in a suitable position and ground it, as necessary.
b) Before the laser is powered on, please check if the power supply has the correct voltage
(380VAC
±
10%, 50/60Hz, See Table 2 Product Technical Data Sheet for details.), and check
whether the grounding line is well grounded.
c) Connect the power cable and control cable to the product when power supply is OFF.
d) Connect the cooling system to the laser and fiber delivery cable connector according to the
water inlet and outlet signs.
e) Please check the fiber delivery cable connector and make sure to clean it before installing it in
the equipment.
f) Do not step on, squeeze or excessively bend the protective tube during the installation of the
fiber delivery cable connector to avoid damage to the optical fiber.
g) In the process of installing the optical cable output head, ensure the cleanliness of the
surrounding environment (do not use electric fans to dissipate heat when it is hot in summer to
avoid large dust in the air).
h) The minimum bending diameter of the laser transmission cable in non-working conditions such
as transportation and storage shall not be less than 40cm.
i) Customers can use the four lifting rings at the top of the product or the four casters at the
bottom to lift or move the product. Before lifting the laser source, make sure that the four lifting
rings are installed firmly and reliably. When lifting the laser source, be sure to use the four
lifting rings; when pushing the laser source, please make sure that the support block at the
bottom of the horizontal adjustment caster is off the ground. After the laser source is positioned,
adjust the support block to make it contact the ground to avoid displacement of the laser source.
As shown in Figure 5.
