RaycoWylie i4000, Инструкция по калибровке

Страница: 6 / 31

55M4000BCE00 REV A
6
1 INTRODUCTION
This manual contains calibration information for the i4000 system. When performing
calibration of the i4000 system, always observe the safety rules and regulations
applicable in the country of operation to reduce the risk of personal injury or damage to
the equipment. Each safety instruction throughout this manual must be taken into
consideration when using the i4000 system. The information contained in this manual
will enable qualified personnel to properly operate and efficiently perform calibration.
1.1 Personnel qualification and scope of this manual
Installation of the i4000 system shall be performed by a qualified technician.
Furthermore, calibration of the i4000 system
must be performed by a RaycoWylie
trained technician. The RaycoWylie technician will perform a complete and structured
verification of the whole system before beginning the system’s calibration.
Failure to calibrate the system properly can result in overloading of the crane risking
machine breakage or tipping that could result in serious injury or death. Always refer to
a
RaycoWylie trained technician to calibrate your system.
1.2 Using this manual
This manual must be used in conjunction with the Instruction Manual, refer to the
instruction manual for description of the system operation, especially the section
“Description of operation keys”.
All numbers shown on sample screens are examples only and must be substituted with
real information from the machine.