RaycoWylie i4000, Инструкция по калибровке

Страница: 12 / 31

55M4000BCE00 REV A
12
mode. If the wind speed goes over this approach gap an intermittent audible alarm
will be activated and the yellow display LED will blink.

App Rotation(if Rotation sensor fitted) : This variable represents an approach
warning gap before to reach the slew limit set by the operator in the normal mode. If
the slew goes over this approach gap
an intermittent audible alarm will be activated
and the yellow display LED will blink.

Time of return : This is the time that you have to return into safe condition before
the motion cut output will be activated, when you reach a limit.
2.6 Step #6: “Dimensions” Data entry
This menu contains crane dimensions that are necessary for the calculation of the load
radius and height of the boom tip.
Some or all of this information may be pre-loaded prior to delivery but all dimensions
should be verified and edited as required before proceeding. Units in use will be feet or
meters depending on the setting made for ‘calib units’ in step #3. To enter a negative
value press on
“+/-“ to toggle between positive and negative value.

CL1 (full retract): length of the main boom when fully retracted.

CL2 (Ext + Man)): length of the boom with all sections fully extended including any
manual or power pinned extension if fitted.

CL2MR (Ext + Man): length of the boom fully extended but with any manual or
power pinned extension retracted. Note: For full power booms without a manual
section
CL2 and CL2MR are the same value.

CL8 (p2cb) – vertical distance between the boom foot pin and the boom centerline
with the boom horizontal. Instead of using the boom centerline as a reference, It is
common to use the boom foot pin, in this case CL8 = 0 but ensure that CL10 and CL11
use the same reference.

CL10 - vertical distance between the lower boom tip sheave pin (hook suspension
sheave) and the boom centerline (or boom foot pin, see CL8) with the boom
horizontal.

CL11 - vertical distance between the upper boom tip sheave pin and the boom
centerline (or boom foot pin, see CL8) with the boom horizontal.

CR1 (Sheave Rad.) - lower boom tip sheave pitch radius (hook suspension sheave).

CF (slew offset) – horizontal distance between the boom foot pin and the centerline
of rotation of the machine. If the boom foot pin is behind the centerline of rotation
then the distance is negative, otherwise it is positive.

CH1 (height offset)
–
vertical distance between the boom foot pin and the ground.

Nb Jib
– Number of jib available to calibrate
, if this value is greater than 0, we will have
to enter dimension shown in “Fly jib geometry” for each jib.