6
P/N 016-0171-277 Rev. L
107
ENVIZIO PRO AND CRUIZER II CALIBRATION AND OPERATION
FIGURE 10. Machine Configuration Menu
3. Select one of the
Profile
options
from the bottom of the Machine Type list.
4. Select
Next
.
5. Select
New, Load,
or
Reset
.
•
New creates a new machine profile.
•
Load allows the operator to select an existing profile. Load will not be displayed as an option until a
machine calibration has been performed and a new profile has been set up.
◦
If the profile chosen has previously been calibrated on the machine, the calibration process is
complete.
◦
If the profile chosen has not been calibrated on the machine, the calibration process must be
completed as outlined in the following sections in this manual.
•
Reset clears the previous profile settings. Once Reset is selected, the operator must select the machine
from the Machine Type list and the calibration process must be completed as outlined in the following
sections in this manual. Reset will not be displayed as an option until a machine calibration has been
performed and a new profile has been set up.
6. Select
Next
.
MACHINE-SPECIFIC CONFIGURATION
NOTE:
Refer to the Envizio Pro™ and Envizio Pro II® Installation and Operation Manual (P/N 016-0171-148)
or Cruizer II Operation Guide (P/N 016-0171-415) for information on additional machine
measurements (such as guidance width) that must be entered into the field computer.
Before the SmarTrax system may be enabled, the SmarTrax system must be calibrated for the specific vehicle
being used. Complete the following steps to configure the machine specifications in the field computer and the
SmarTrax system.
Содержание SmarTrax
