Raven SC1, Руководство по эксплуатации

Страница: 13 / 111

Initial Machine Calibration: Initial Machine Calibration 9
INITIAL MACHINE CALIBRATION
GPS SETUP
NOTE: System Information, Diagnostic Trouble Codes (DTCs),
and Machine Test pages may be viewed during the
calibration process. For additional assistance with the
settings available on these pages, please refer to the:
•
System Information section on page 89
•
Diagnostic Trouble Codes (DTC) section on page 67
•
Wheel Angle Sensor Settings section on page 46.
NOTE: The Machine Test icon will only be displayed if a Steering Partner is detected.
3. Use the drop-down options to select the Machine Type, Machine Make, and Machine Model most closely
matching the equipment used for the current machine configuration.
4. When all options have been set, select the Next button. One of the two following pages will be displayed.
• Steering Partner Not Found
• Steering Configuration
FIGURE 1. Steering Partner and Configuration
5. Select the GPS Only Configuration button to set up and use only the GPS features of the SC1/TC1 system.
Proceed to step 6 to continue the GPS Only Configuration.
To calibrate both the GPS and auto-steering features of the SC1/TC1 system, confirm that the Steering
Configuration page displays the correct Steering Partner and touch the Next button.
6. Use the drop-down to select the appropriate GPS receiver.
Information Alarms Machine
Test