Raven OMNiDRIVE, Инструкция по установке и эксплуатации

Страница: 15 / 275

Important Safety Information
l
Indirect vent chemical splash goggles or indirect vent chemical splash
goggles with full-face shield.
l
Check operation of system components (e.g. valves, temperature and pressure
gauges) prior to charging the system with NH3.
l
Seek immediate medical attention if symptoms of illness occur during or shortly
after use of NH3 products.
l
Use extreme caution when servicing or maintaining a system that has previously been
pressurized with NH3.
l
Keep a source of clean water (at least five gallons) readily available while working
with NH3. This source should be in addition to, and separate from, the water
source on the nurse tank.
l
Read and follow instructions provided with the application system to properly dis-
charge NH3 before performing service or maintenance.
l
Pressure gauges can fail, become plugged, or display incorrect pressure. Slowly
bleed pressure from a previously charged system by opening valves slightly.
Allow pressure to discharge for an extended period of time. Treat every section
where NH3 can be trapped as though it is pressurized.
l
Thoroughly bleed all system lines and disconnect the nurse tank hose to remove
NH3 from the system before transporting the system or beginning service or
maintenance. Liquid NH3 can absorb heat from surroundings and re-pressurize
the system. Any bleed valves that are opened to relieve pressure should remain
open while transporting the system or maintenance is being performed.
l
Stand ‘up wind’ when working around NH3 and related equipment. Never work
on NH3 equipment in confined spaces. Always keep NH3 equipment away from
buildings, livestock, and other people.
l
Before each days use:
l
Visually inspect all system plumbing components for functionality, excess-
ive wear, and damage.
l
Some components may have recommended “replace by” dates or max-
imum service periods regardless of visual condition.
l
Replace individual components if excessively worn, visually damaged, or
non-functioning, as recommended by the component manufacturer, or as
required by regulation, whichever is sooner.
15