Ravaglioli G7645 Series, Инструкция по эксплуатации

Страница: 31 / 194

31 7300-M009-0_R
GB
I. WHILE OPERATING, SERVICING OR REPAIRING THE MACHINE, DO NOT WEAR LOOSE CLOTHING,
NECKTIES, NECKLACES OR OTHER HANGING ACCESSORIES. LONG HAIR IS ALSO HAZARDOUS
AND SHOULD BE TIED UP.
J. OPERATORS SHOULD WEAR SUITABLE PROTECTIVE CLOTHING LIKE GLOVES, SAFETY
FOOTWEAR, SAFETY EYEWEAR AND HELMET, IF REQUIRED.
K. THE WORKSHOP MUST BE KEPT CLEAN, DRY AND NOT EXPOSED TO ATMOSPHERIC AGENTS.
MAKE SURE THE WORKING PREMISES ARE PROPERLY LIT.
L. MACHINES MUST BE OPERATED BY A SINGLE OPERATOR ONLY. UNAUTHORISED PERSONNEL
MUST REMAIN OUTSIDE THE WORKING AREA, AS SHOWN IN FIG. 4.
M. WHILE OPERATING THE MACHINE, OBSERVE THE WORKING POSITIONS AS SHOWN IN FIG. 4:
A - WHEEL POSITIONING
B - WHEEL BEADING
N. AVOID ANY HAZARDOUS SITUATIONS. DO NOT USE PNEUMATIC OR ELECTRICAL EQUIPMENT
WHEN THE SHOP IS DAMP OR THE FLOOR SLIPPERY AND DO NOT EXPOSE SUCH TOOLS TO
ATMOSPHERIC AGENTS.
0.4 Indication of outstanding risks
The machine was designed and manufactured in compliance with applicable regulations. The risks
connected to the use of the machine have been eliminated as far as possible. Other outstanding risks are
described in this manual; the machine also features self-adhesive pictograms indicating hazard areas.
In the event pictograms become illegible, please order them from a dealer or directly from the manufacturer,
and replace them. Please refer to Table 1, Pictures 2 (for non “I”models), Pictures 3 (for “I”-"IT" models).
1. PRELIMINARY INFORMATION
1.1 Safety devices
All machines are equipped with the following:
• “operator attending” controls (immediate stop by releasing control) for: spindle rotation, beader blade motion,
inflating; other drives such as rim clamping on spindle, head clamping cannot be of the operator-attending type,
seen their function. In these cases safety is guaranteed by compliance with indications or precautions on
machine residual risks (warning plates) also mentioned in the user’s guide.
All machines can also be used for inflating tires (“I”-"IT" versions and G84A14N and G84A15N accessories for “non-
I” versions) and are equipped with the following:
• pressure gauge for tyre pressure reading, EC-certified and in compliance with 86/217/EEC Standard;
• motor protection devices (for G7645D.XX_G7645ID.XX_G7645ITD.XX models). The new "invemotor" is
equipped with electronic protection devices. They stop the motor if working defected conditions appear to avoid
that the motor it-self can be damaged and that the operator safety can be compromised (overvolatage, overload,
overtemperature). For other details, see the chapter 8 "TROUBLESHOOTING".
• Max. pressure valve fitted on compressed air reservoir (preset – see pneumatic diagram) in compliance with 87/
404/EEC Standard.
• Pressure limiter with fixed setting. Used to inflate the wheel in reasonably safe conditions.This limiter does not
allow inflation to a pressure in excess of 4,2 bar (60 psi).