Rauch TWS 85.1, Инструкция по эксплуатации

Страница: 67 / 104

Instructions for load transfer
61
7
7.4 Set the auger conveyor speed
The auger conveyor speed has been preset at the factory . Usually, no additional
adjustment is required. If the hydraulic capacity of your tractor is too low you may
adjust the speed using the electronic
QUANTRON-A control unit for TWS .
1. Open the menu Machine settings > Auger .
Figure 7.2: Controlling the hydraulic system
[1] Auger conveyor speed in RPM
[2] Performance value of the auger conveyor in %
[3] F2 function key: Continuous operation
[4] F3 function key: Jogging mode
2. Turn the hydraulic system of the tractor to full power.
3. Start the auger conveyor by pressing the F2 function key
4. Set the required speed by means of the PWM value.
5. Turn the hydraulic system of the tractor down until the auger conveyor speed
is below the minimum value.
6. Slightly increase the volume flow at the tractor.

The control block runs in saturated state (all hydraulic components are op-
erating).
7. Stop the auger conveyor by pressing the F2 function key
n
WARNING
Risk of injury due to moving parts
There is a risk of injury during auger conveyor operation.
 Ensure that nobody is in the hazard zone.
Auger
RPM
1
2
3 4