Spreading width too wide
u
Set the position of the first specified spreading vane to the next smaller working width according
to the fertilizer chart.
w
e.g. E4-C1 (18 m) to setting D4-C1 (15 m)
Spreading width too narrow
u
Set the position of the first specified spreading vane to the next larger working width according to
the fertilizer chart.
w
e.g. D4-C1 (15 m) to setting E4-C1 (18 m)
9.10
Full or limited border spreading
Full border spreading is fertilizer spreading at the boundary in which fertilizer goes beyond the
boundary, but there is only slight underfertilization at the field boundary.
With limited border spreading, virtually no fertilizer goes beyond the boundary, so underfertilization at
the field boundary must be accepted in this case.
Only full border spreading is possible with the basic machine equipment.
For limited border
spreading, you need the GSE 7 or TELIMAT T1 special equipment.
9.10.1
Full border spreading from the first track
u
Set spreading vanes on the boundary side as specified in the fertilizer chart.
w
See
The metering slide adjustment matches the metering slide adjustment on the field side. See
9.10.2
Setting the GSE spreading width limiter
The spreading width limiter limits the spreading width (either towards the left or right) to a range
between approx. 75 cm and 2 m from the center of the tractor track to the outer edge of the field.
u
Close the metering slide that points to the border of the field.
w
See
u
Fold the spreading width limiter downwards for limited border spreading.
u
The spreading width limiter must be folded up again before two-sided spreading.
The settings for the spreading width limiter refer to the
spreading disc working towards the
inside of the field
.
9. Spreading operation
94
5902916
MDS 8.2/14.2/18.2/20.2
