u
Insert the adjustment lever into the locking
bolt opening [3] under the spreading disc.
u
Press down.
The locking bolt [2] is released.
Fig. 43: Spreading vane settings
u
Set the angle and length of the spreading vane.
u
Press the locking bolt up with the adjustment lever until it engages.
WARNING!
Risk of injury due to improperly installed parts
A risk hazard is posed if the locking bolt does not properly latch into the spreading disc.
Loose components can cause injuries or material damage during operation.
u
After setting, fully engage the locking bolts again.
NOTICE!
Danger of material damage: Do not over-bend the flat spring
The flat spring tension must reliably lock the main and extension vanes onto the spreading disc. If
the flat spring is over-bent, then it loses the tension required to secure the spreading vane.
If the spring tension is too low, the locking bolt disengages and can cause significant material
damage.
u
When setting the spreading vane position, carefully press the locking bolt into any positioning
hole.
u
If the spring tension is too low, replace the flat spring immediately.
9.5
Using the fertilizer chart
9.5.1
Information on the fertilizer chart
The values in the fertilizer chart have been determined using the manufacturer’s test system.
9. Spreading operation
80
5902916
MDS 8.2/14.2/18.2/20.2
