Rau 08-AT, Руководство по эксплуатации

Страница: 40 / 44

16
5.3 Electrical connection
Lay the cables so that they cannot be damaged and nobody can trip over them. Avoid slips, trips and
falls.
Check that the operating voltage of the local power supply matches that of the workstation. (See rating
plate on the controller, standard=230V).
6. Operating
Please note that the workstation should always be used within the scope of the technical data.
When raising and lowering the worktop with the control unit, there is a risk of crushing. Only
operate the control unit if you have an unrestricted view of the workstation. Do not reach into
the barrel of the guide columns during the raising and lowering process.
6.1 Backing up and procedures
Before each use of the workstation, check for visible damage. Before each use, make sure that
the workplace has been set up in accordance with this manual and that no objects, such as
the power cord, can be trapped.
Pull out the mains plug before moving the workstation and, if necessary, release the parking
brakes of the wheels. Reseat it at the new destination and reinsert the power plug.
6.2 Operation with standard control panel
Control element standard only allows to adjust the worktop height.
Use the left arrow to move the worktop up. Press the right arrow to move down.
Standard control panel
6.3 Operation with comfort control panel (optionally available)
Control unit comfort allows you to adjust the worktop height, display it digitally and offers a memory
function for up to three positions. If the control unit is not used, the display switches off, thus saving
power in stand-by mode. In addition, the display shows fault codes of the drive system and thus acts
as a diagnostic tool. Use the left arrow to move the worktop up. Press the right arrow to move down.
The current worktop height is shown on the right side of the display.