Original instructions
ASSEMBLY
KNOB
Fig.10
Fig.11
1.Push left the front handle on the shaft tube. Then inset the barrier on the front handle until the position pin on
the shaft tube.(see Fig.8)
2. Fit the nut into the hole.(see Fig.9)
3.Fit the barrier and handle onto the shaft pipe with the knob. Make sure Position the barrier on the left side
of the tool.(see Fig.10)
4.Tight the knob so that the grip/barrier assembly cannot move or rotate on the shaft pipe.(See Fig.11)
Installing the guard
(see Fig.10).
GUARD
MOTOR HOUSING
SCREW
Fig.10
•
Fit the trimmer guard onto motor housing, then tighten three screws so that the guard assembly cannot move.
16-English
