Original instructions
ASSEMBLY
4.Keep the side with letters on the spool visible on the top. Now, unhook the ends of the cord from their
temporary position and feed the cords through the eyelets to come out of the cover.(see fig.14)
5. Push cover firmly onto the housing to secure it. Make sure the latches fully spread in the cover(see fig.15)
WARNING(For BBC236DH)(see fig.16)
•
Always position the equipment on your right-hand side so that the shaft of the left handle is always in front of
your body. Correct positioning of the tool allows for maximum control and will reduce the risk of serious personal
injury caused by kickback.
WARNING(For
RBDM40
) (see fig.16)
Always position the equipment on your right-hand side so that the shaft of the barrier is always ahead of you.
The correct posture reduces the risk of injury caused by kickback.
Fig.16
Attachment of shoulder harness
(see fig.17-18)
Fig.17
Fig.18
Hang the shoulder harness on your left shoulder with putting your head and right arm though it. Buckle it to the
hook unit until a click is heard. Make sure that it cannot be taken off with pulling it off. Hang the machine as
shown. Adjust the strap length so that the cutter blade will be kept parallel with the ground at the level of 10 to 30
cm (4" to 12") above the ground.(see fig.17)
In case of emergency, press the emergency detachment lever strongly.(see fig.18)
WARNING:
•
Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be
deflected toward you or anyone in the work vicinity.
Failure to do so could result in serious injury.
19-English
