Original instructions
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any
work on the tool Failure to switch off and remove the battery cartridge may result in serious personal injury
from accidental start-up..
•
Never start the tool unless it is completely assembled. Operation of the tool in a partially assembled state
may result in serious personal injury from accidental start-up.
Installing the handle and grip (For model BBC236DH)
(see Fig.7)
NUT
HANDLE
SCREW(A)
GRIP
HANDLE HOLDER
SCREW(B)
HANDLE CLAMP
Fig.7
1
2
1.Loosen knob
Place handle between handle clamp and handle holder. Adjust the handle to an angle that provides a comfortable
working position and then tighten four screws(A) so that the handle assembly cannot move.
2.Place grip cover the handle and grip hold
（
1
）
. Adjust the handle to an angle that provides a comfortable working
position
（
2
）
and then tighten one screw(B)and one nut so that the grip assembly cannot move .
Installing the handle and grip (For model
RBDM40)
(see Fig.8-11)
FRONT
HANDLE (A)
NUT
HOLE
BARRIER
PPSITION PIN
Fig.8
Fig.9
15-English
