Rato R1000I, Руководство по обслуживанию

Страница: 14 / 47

Part 3 Failure Determination and Repair Preparation
3-1 Safety Factors
Failure to observe the following precautions will result in the invalidation of the
warranty provided with the generator and may damage the generator or cause personal injury.
Therefore, before using the generator, Operators should pay special attention to the following points:
1. It shall be matched strictly according to the power demarcated in the maintenance manual, and it is
strictly forbidden to run under overload, over-speed or low speed for a long term.
2. Using the fuel oil and engine oil of specified ratings, conduct sufficient sediment and filtering before
using them. Refueling appliance shall be maintained clean, and engine oil shall be replaced
regularly.
3. Check if the fastening bolts on generator are tight enough regularly and tighten them in time
4. Clean air filter elements regularly and replace them when necessary.
5. This machine is a wind-cooled generator, so be sure to clean the sundries and dirt on its parts like
cooling fin and wind scooper in time to ensure the normal cooling performance of generator.
6. Operators should be familiar with the working principles and structure of the generator and know
how to stop it in emergency and operate all the control components. Be sure to conduct regular
maintenance and timely eliminate the faults found; it’s prohibited continuing to run the generator
after faults happen to it.
7. Please be sure to keep the generator at least one meter from buildings and other equipment when
operating it and keep good ventilation; do not put any inflammable (like gasoline and matches)
beside the generator or close to the running generator to prevent the fire risk.
8. Refuel the generator at the place with good ventilation and with it standstill and no smoking, open
fire or spark in the place where the generator is refueled or in the fuel storage place.
9. Do not overfill the oil tank and the fuel oil shall not overflow. If there is fuel overflowing, overflowed
fuel must be cleaned thoroughly, and the generator shall not be started up until the fuel is volatilized
off.
10. Do not operate the generator in a confined or poorly ventilated area.
11. When the generator is running or just stopped for a period of time, do not touch the muffler to avoid
being burned. In order to prevent burn or fire, in order to avoid scalding or fire, the generator shall
be transported or stored after cooling.
12. Safety Warning Label
Please read the warning label carefully before using the generator; our company shall not be liable
for the personal injuries or equipment damages caused by ignoring the warning label.