Rasilient Confidential
- Use or disclosure of data contained on this page is subject to the restriction on the title page
of this document.
42
Pull out Chassis from Rack
WARNING
: To avoid the risk of personal injury or equipment damage, be sure that the rack is adequately
stabilized before extending a component from the rack.
WARNING
: To avoid the risk of personal injury, be careful when sliding the chassis into the rack. The
sliding rails could pinch your fingers.
WARNING
: When install the system in the rack be sure to start from the bottom to the top. Do not install
the system in the rack from top to bottom.
Drive Installation
Install 3.5 inch Drive into carrier
Both 3.5 inch and 2.5 inch can be easily assembled in the same carrier. Rasilient will
provide a kit with all the parts necessary for the installation.
Step
: Install 3.5 inch drive to the carrier.
Figures below show a detail sequence of pictures that show the proper kits and method
of assembling. These methods must be followed or failure could occur to the isolator if
not properly installed.
Figure 27: Pull out chassis from rack
