Rasilient Confidential
- Use or disclosure of data contained on this page is subject to the restriction on the title page
of this document.
45
Install 2.5 inch Drive into carrier
Both 3.5 inch and 2.5 inch can be easily assembled in the same carrier. Rasilient will
provide a kit with all the parts necessary for the installation.
Step
: As Figures below show a detail sequence of pictures that show the proper kits
and method of assembling. These methods must be followed or failure could occur to
the isolator if not properly installed.
Figure 30: Drive Carrier Kit for 2.5" Drive
2.5 inch Hard Disk X1
SCREW X4, M3X0.5X4.7, PH, FLT, ST, ZN
Screwdriver used: PH2
Screw torque: 4.5 +/- 0.5kgf.cm(4 lbf.inch)
Step 1
: Place hard disk into carrier by locating four holes.
