Rasilient PixelStor 5000, Руководство пользователя

Страница: 129 / 161

Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013 7-92
This section describes how to access the CLI and provides a list of commands that can be
used for system configuration, array management and administrative functions.
7.2
Connecting a Terminal to Access the CLI
Connect the supplied Serial cable to the Serial management port on either controller. Connect
the opposite end of the cable to a workstation or laptop with a terminal emulation program. A
DB9 connector is provided for the workstation or laptop.
Use the following terminal emulation settings to access the CLI:

Baud Rate
– 115,200

Data Bits
– 8

Parity None

Stop Bits
– 1

Flow Control Off
7.3
Accessing the CLI – Serial Port or Telnet Session
Once connected to the Serial port with the PixelStor 5000 is running, you will be prompted for
the following information:

Login
– root

Password
– root
When connecting through a telnet session connect to the
PixelStor 5000
with “telnet <IP
Address>”. You will be prompted for the following information:

Login
– guest

Password
– welcome
Enter SuperUser mode by executing the “su” command (pwd is “root”). CLI commands must
be executed as a SuperUser.
7.4
dahelp Command
The “dahelp” command lists all available CLI commands for the
PixelStor 5000 .
Detailed information for each CLI command is listed on the screen by simply executing
the specific command without parameters or by specifying the “?” parameter.