444
This section explains how to use the command line interface (CLI) to
administer a PX3 device.
CLI commands are case sensitive.
In This Chapter
About the Interface.................................................................................. 444
Logging in to CLI...................................................................................... 445
The ? Command for Showing Available Commands............................... 448
Querying Available Parameters for a Command.................................... 449
Showing Information ............................................................................... 450
Clearing Information ............................................................................... 482
Configuring the PX3 Device and Network ............................................... 483
Load Shedding Configuration Commands .............................................. 618
Power Control Operations....................................................................... 620
Actuator Control Operations ................................................................... 623
Unblocking a User ................................................................................... 625
Resetting the PX3 .................................................................................... 625
Network Troubleshooting ....................................................................... 627
Retrieving Previous Commands.............................................................. 630
Automatically Completing a Command .................................................. 630
Logging out of CLI ................................................................................... 631
About the Interface
The PX3 provides a command line interface that enables data center
administrators to perform some basic management tasks.
Using this interface, you can do the following:
Reset the PX3 device
Display the PX3 and network information, such as the device name,
firmware version, IP address, and so on
Configure the PX3 and network settings
Troubleshoot network problems
You can access the interface over a local connection using a terminal
emulation program such as HyperTerminal, or via a Telnet or SSH client
such as PuTTY.
Note: Telnet access is disabled by default because it communicates
openly and is thus insecure. To enable Telnet, see
Changing Telnet
Settings
(on page 281).
Chapter 8
Using the Command Line Interface
Содержание PX3-3000 series
