Chapter 6: DPX Series
60
3.
Use a screwdriver with a 2.5 mm wide shaft to tighten the screws
above each termination point to secure the wires, using a torque of
0.196 N·m (2 kgf·cm).
To make connections after the terminal module is separated:
You can also connect a detector/switch when the terminal module is
separated from the sensor box.
1.
Loosen the screws at two sides of the terminal module.
Note: The two screws are not removable so just loosen them.
2.
Separate the terminal module from the sensor box.
